In this master thesis, the student will investigate different linear motor types and
topologies for the future 3km AlphaTube vacuum transport demonstrator, such as the
permanent magnet synchronous motor and the synchronous reluctance motor. - Electrical Engineering
- Master Thesis
|
In this project, you will compare conventional LCL-filter design methods and analyze the impact of controllers on the design methods. Then, you will investigate a new design method of LCL filters when MPC is applied. - Electrical Engineering
- Master Thesis
|
In this master thesis, the student will consider the expected power profile of a
hyperloop vehicle, and the models relative to the propulsion and levitation systems will be
extracted and compared with the corresponding one of high speed railway. After having
established the expected performance, the thesis will focus on which power system
architecture is most suitable of future Hyperloop systems. - Electrical Engineering
- Master Thesis
|
In this project, you will first analyse an implemented quadratic program (QP) solver using Intel high-level-synthesis (HLS) tool and develop an optimization routine to compare the performance considering hardware resource constraints. - Electrical Engineering
- Master Thesis
|
In this project, you will search the suitable current measurement methods and design the measurement system for strand current. You will validate your design with simulation tools like FEM. Finally you will implemented and test your design. - Electrical Engineering
- Master Thesis
|
In this project, you will implement analytical switching loss models from literature in Matlab, simulate switching losses in LTspice, and compare them to the measurement results with an existing PCB. - Electrical and Electronic Engineering
- Master Thesis, Semester Project
|
Development of a software tool which visualises the geometry of a basic switching cell based on geometrical parameters derived by converter optimisation procedures - Electrical Engineering
- Master Thesis, Semester Project
|
Development of switching cell mechanical models in the X3D format based on geometrical parameters derived by converter optimisation procedures - Electrical Engineering
- Master Thesis, Semester Project
|
In this project, you will extend an analytical SiC MOSFET switching loss model to GaN HEMTs in Matlab, simulate switching losses in LTspice, and compare them to the measurement results with an existing PCB. - Electrical and Electronic Engineering
- Master Thesis, Semester Project
|
In this project you will model the 3D geometry of litz wire by a mathematical algorithm. Furthermore, the current density distribution and the eddy current losses should be calculated for different termination strategies and for different litz wire geometries by FEM. The impact of improper terminations should be qualitatively/quantitatively analysed. - Electrical and Electronic Engineering
- Semester Project
|